Short answer
Connect the controller, open the online gamepad tester and press any button. Put the controller on the desk and watch the Off centre value: when it is larger than the dead zone covers, the dot turns red – that is drift. The Xbox controller battery, the Guide button and Windows calibration are handled by HidTester.
Step by step
-
Connect the controller
By cable or Bluetooth (the controller must be paired in Windows). Xbox, PlayStation (DualShock 4, DualSense), Switch Pro, 8BitDo, joysticks and wheels all work. PlayStation and Switch controllers need neither DS4Windows nor Steam.
-
Open the tester and press a button
In the online gamepad tester the controller appears only after the first press – the browser hides it until then for privacy. In HidTester it shows up right away.
-
Put the controller down and do not touch the sticks
Off centre shows how far from the centre a released stick sits. A few percent is normal. When it is further than the dead zone (24 % for Xbox, the test uses 15 % for others), the dot turns red.
-
Circle the stick along the edge
Slowly turn the stick all the way round its edge. The line shows how far the stick reaches and the test calculates the average deviation from a circle. A healthy stick is usually within 10 %; a flattened spot gives away a worn potentiometer.
-
Look at the axis noise
Noise is how much the value wobbles while you do not touch the controller. Above 0.02 on a released stick points to a dirty or worn potentiometer.
What to do with the result
| Result | What to do |
|---|---|
| Off centre a few percent, dot green | Fine, the game's dead zone covers it. |
| Dot red, little noise | Drift. Try cleaning the stick with contact spray; replacing the stick module is the lasting fix. |
| High noise, the value jumps | A dirty or worn potentiometer – same fix. |
| Circularity well over 10 %, a flat spot | A worn stick or a faulty cap. |
For joysticks and wheels, the Windows calibration… button in HidTester opens the Game Controllers window (joy.cpl), where the device is calibrated, and HidTester shows the result straight away. Xbox controllers have no calibration in Windows – for them the measurement tells you whether to clean or replace the stick.
Things to keep in mind
- When Steam is running, it can take over a PlayStation or Switch controller and present it as an Xbox controller.
- Windows or Steam usually keep the Guide (Xbox) and PS buttons for themselves, and the browser cannot read the battery level. HidTester, which reads Xbox controllers through XInput, shows both.
- The online test also works in Chrome on Android; Safari on iPhone supports Xbox and PlayStation controllers.