What the mouse test shows
- Buttons: left, right, middle (wheel click) and the side Back and Forward (X1, X2). A pressed one lights blue on the picture, a tried one green. The page blocks the side buttons so they do not take you back a page.
- Double-click test and chatter: when a button fires again less than 30 ms after its release, that is a worn switch bouncing, not a finger. It is exactly what a mouse that "double-clicks by itself" or drops a dragged window looks like. The Min. gap column shows the shortest gap seen on that button.
- Wheel: rolling up and down and tilting left and right, if the mouse has it. A wheel that sometimes jumps the wrong way shows up in the opposite counter.
- Report rate: how many times a second the mouse sends its position. It is worked out from the median gap between move events, so a short pause does not skew it.
- DPI: how many counts the mouse sends per inch of travel. The page locks the pointer and counts the raw movement – without Windows acceleration where the browser supports it.
Report rate in a browser
Chrome and Edge hand the page every single mouse report (pointerrawupdate), so they measure a true 1000 Hz and more. Firefox sends movement per screen frame but bundles every in-between step with it (getCoalescedEvents), so its result is right too. Safari does not give the in-between steps and shows at most the monitor refresh rate. With 4000 and 8000 Hz mice the browser may show less than the mouse really sends, limited by its timestamp precision.
The report rate is set in the mouse maker's software or with a switch underneath. On a wireless mouse with a low battery or far from its receiver it drops and wobbles – the test shows that too.
Questions
My mouse double-clicks by itself. How do I check?
Click the left button at a normal pace for about a minute and watch the Chatter tile. One or two firings under 30 ms mean the switch is starting to fail; under warranty that is grounds for a claim, out of warranty a new microswitch fixes it.
Why is my DPI different from what the maker says?
The quoted DPI is nominal; the real figure differs by a few percent depending on the pad surface. Measure along a ruler 2–3 times and take the average. When the browser cannot give raw movement, the Windows "Enhance pointer precision" option skews the result too.
The side buttons do not work – is it the mouse?
If they do not light up on the picture, Windows is not receiving them: check whether the maker's software assigned them something else. Some mice send them as keys – the keyboard test shows those.