Short answer
Run AccuInfo. The left panel shows the design capacity (what the battery was meant to hold when new) and the full charge capacity (what it holds today), both in mWh. The program works out the battery health as a percentage from the two.
Step by step
-
Run AccuInfo
Just download
AccuInfo.exeand run it, nothing gets installed. The values are read straight from the battery controller (BMS) and refresh every second. -
Find both capacities
The design capacity is the value the manufacturer built the battery for. The full charge capacity is what the battery actually holds today when charged to one hundred percent. Both are in milliwatt-hours (mWh).
-
Read the health
AccuInfo calculates
health = full charge capacity ÷ design capacity × 100. A battery designed for 50,000 mWh that holds 40,000 mWh today has 80 % health. -
Save a report
Save report… writes both capacities, the health, the cycles and the serial number into a single HTML file that opens offline and can be sent as one attachment.
Why the current charge differs from Windows
AccuInfo also shows the current charge, but it calculates it from the capacities rather than the rounded Windows figure. That is why it can differ from the taskbar icon by a few percent. One hundred percent in Windows means "full relative to today's capacity", not to the original one: a worn battery shows a full hundred percent even when it holds only two thirds of what it once did.
- Health 80–100 % — normal, the capacity gap is small.
- Health 50–70 % — the battery holds a third to a half less, and the runtime shrinks accordingly.
- Health below 50 % — the battery has reached the end of its life.
Things to keep in mind
- Some manufacturers fill in the design capacity loosely. Health then comes out absurdly low or even above 100 %. In that case the cycle count and the battery behaviour in the chart are a more reliable guide.
- The full charge capacity can shift slightly after a calibration. A one-off difference of a few percent between two readings is nothing to worry about.
- Windows can save a page with both capacities using
powercfg /batteryreport. AccuInfo adds the cycles, temperature, serial number and live charts.