Short answer
Download AccuInfo and run it, nothing gets installed. Right after start it reads the design capacity, the full charge capacity and the cycle count from the battery controller and works out the battery health as a percentage. Above 80 % the battery is fine; below 70 % it is time to think about a replacement.
Step by step
-
Download and run AccuInfo
It is a single
AccuInfo.exefile of under 200 kB. It does not install and needs no administrator rights. Windows will most likely show a blue SmartScreen dialog for the downloaded file: click More info and Run anyway. -
Look at the battery health
The left panel lists everything the battery reports about itself. Three values matter: the design capacity (what it held when new), the full charge capacity (what it holds today) and the health, the ratio of the two as a percentage.
-
Check the cycle count
The number of charge cycles completes the picture. A battery with 300 cycles and 85 % health is ageing normally; a battery with 100 cycles and 60 % health most likely has a faulty cell.
-
Let the charts run
On the right, the charge in percent and the power draw in watts are plotted every second. If the charge drops several percent at once under load, or the laptop shuts down at 20 %, the cells no longer hold their voltage, even if the health figure looks decent.
-
Save a report
Save report… writes a single HTML file with every value, the battery serial number and the charts. Useful for a warranty claim, when selling the laptop, or as a record for a customer.
How to read battery health
| Health | What it means |
|---|---|
| 95–100 % | A new or nearly new battery. |
| 80–95 % | Normal wear after one or two years. Nothing to do. |
| 70–80 % | Noticeably shorter runtime, but still usable. |
| 50–70 % | Runtime may be halved. Replacing it makes sense if you use the laptop on battery. |
| below 50 % | The battery has reached the end of its life. |
Health is calculated as full charge capacity ÷ design capacity × 100. The values come straight from the battery controller (BMS), not only from the WMI system interface, which is why AccuInfo also sees the serial number, cycle count and temperature that common tools often do not show.
Things to keep in mind
- Treat the number as a guide. Some manufacturers fill in the design capacity loosely, so health can come out absurdly low or even above 100 %. Always compare it with the cycle count.
- Not every manufacturer fills in the cycle count. If the field is empty, the battery simply does not report it.
- Windows can produce a similar overview with
powercfg /batteryreport, which saves a page with the capacities. AccuInfo also reads the cycles, temperature and serial number, draws live charts, and its report is easier to read. - On a desktop PC AccuInfo says it found no battery. Laptops with two batteries show both, selectable from a list.