Short answer
Run LANtester, point it at a NAS share holding a large file (1 GB or more) and press Start test. With Bypass cache on, every byte really crosses the network and the top chart shows the real read speed in MB/s and Mb/s. A gigabit link in good shape gives about 110 MB/s. It measures reading from the NAS to the PC, not writing.
Step by step
-
Put a large file on the NAS
Place a file of at least 1 GB in the shared folder, such as a video or a disk image. The larger it is, the less the overhead of opening files matters.
-
Enter the path in LANtester
Type
\\nas\shareor the IP address with the share name into the Share / drive field, or the letter of a mapped drive (Z:\); the program finds the server behind it. Browse… offers a picker. If the NAS needs another account, fill in the user and password. -
Leave Bypass cache on
Without it Windows would serve the file from RAM after the first read and the chart would show a meaningless several GB/s. If the share does not support bypassing the cache, the program falls back to normal reads and says so in the log.
-
Start the test and watch the chart
Start test reads the file over and over. A few minutes are enough for the average; a longer run shows whether the speed holds or drops after a while (heat, a full disk cache in the NAS).
-
Save the report
Save report… saves an HTML file with average, peak and minimum throughput, total data transferred, ping and the network adapter's link speed.
What to expect
| Link | Reasonable read speed |
|---|---|
| 100 Mb/s | about 11 MB/s |
| 1 Gb/s | about 110 MB/s |
| 2.5 Gb/s | about 280 MB/s, if the NAS disks keep up |
| 10 Gb/s | depends mainly on the NAS disks and CPU; raise Threads to 8–16 |
If a gigabit setup gives around 11 MB/s, the link negotiated only 100 Mb/s; the link speed is in the report next to the adapter. If the speed is well below expectations and the link is right, the NAS disks or CPU are the bottleneck, or the Wi-Fi between the PC and the router.
Things to keep in mind
- LANtester measures sustained reading from a share. It does not measure write speed to the NAS or handling thousands of small files, which are usually slower.
- Measure over cable. Over Wi-Fi you see the Wi-Fi speed, not the NAS.
- Threads (default 4) sets the number of parallel reads; 2–4 fill a gigabit link. Leave Block (kB) at 1024.
- The chart watches for dropouts too. If the speed occasionally falls to zero, see how to test a network card or cable.