Short answer
Download LanAuditPro, run it and press Scan (F5). In about a minute it goes through the whole network and lists the findings worst first: services reachable without a password, outdated protocols, a router or NAS that no longer gets updates, ports opened to the internet through UPnP. The network gets a grade from A to F, and every finding comes with an explanation and advice on what to do.
Step by step
-
Run LanAuditPro in the network you want to check
A single
LanAuditPro.exeof about 1 MB, no installation and no administrator rights. The PC has to be connected to the network you are checking. To have Wi-Fi encryption checked too, use a laptop on Wi-Fi rather than on cable. -
Start the audit
F5 audits the PC's whole subnet. Progress is visible throughout, and the log at the bottom prints every open port as soon as it is found. A home network with a few dozen devices takes about a minute.
-
Go through the findings, worst first
The Findings tab sorts by severity: Critical, High, Medium, Low and Info. Select one and the right side shows what it means, what to do and what it is based on, such as a service banner or a record from the NVD vulnerability database.
-
Look at the individual devices
The Devices tab shows every device with its ports and everything it said about itself. A double-click opens its web page, where most problems get fixed: switch off UPnP, Telnet or WPS, set a password, update the firmware.
-
Save the report and audit again
Ctrl+R saves the whole audit as a single HTML file. After your fixes, run the audit again: the program remembers the last one and shows new devices, newly opened ports, what disappeared, and the previous grade.
What the audit checks and how to read the grade
| Area | Example findings |
|---|---|
| Network and Wi-Fi | Wi-Fi without encryption, with WEP or old WPA/TKIP, UPnP and forwarded ports, double NAT, new devices since last time. |
| Router | A model the vendor no longer ships firmware for, management over unencrypted HTTP, WPS switched on. |
| Services | Telnet, FTP, SMBv1, Remote Desktop, VNC or MQTT without a password, Android debugging (ADB), databases. |
| Cameras and NAS | RTSP video without a password, old Hikvision firmware, Synology DSM past end of support. |
| Smart home | Tuya by protocol version, Home Assistant with unfinished setup, Shelly without a password, Matter in pairing mode. |
The network starts at 100 points and each finding takes some off according to severity. The grade has a ceiling: one high finding means C at best, a critical one D at best, two critical ones F. Twenty minor issues can never outweigh one camera anyone can get into.
Things to keep in mind
- Only audit networks that are yours or that you are allowed to test. LanAuditPro breaks nothing, never tries passwords and changes nothing on the devices, but a port scan may not be welcome on someone else's network.
- A network-protecting antivirus on another PC may report the audit as an attack from your PC's address. It is this audit, not an intrusion.
- The program sees the network from the inside. It does not know how strong your passwords are, whether your cloud accounts use two-factor authentication or what is forwarded by hand on the router. That is why the report ends with a list of things to check manually.
- A version match in the NVD does not yet mean a hole, as vendors often patch without changing the version. Such a finding therefore never gets more than Medium.
- The security of the PC itself (Defender, firewall, BitLocker) is checked by PCHealthLab.